Holtek - e-WriterPro2 - Programmer
The e-Writer series writers - are writers designed for programming Holtek MCUs. These writers can be used to write programs or data to all of Holtek’s OTP and Flash MCUs. The special features of these writers lies in their small and light profile. The installation process is simple and the functions are easy to use.
The e-WriterPro2 from Holtek supports an On-Line Programming Mode that requires connection to a PC and also an Off-Line Programming Mode that does not require a PC. In the Off-Line Mode, after downloading the programming data to the writer using the HOPE5000 using a PC, the writer can be operated without connection to a PC. In the On-Line Mode, a USB cable is required to connect the writer to a PC, after which it can be controlled using the HOP5000. Because Holtek devices are provided in many different package types, a range of corresponding programming adapters are supplied for each kind of MCU package. Therefore for the e-WriterPro2, it is necessary to use the proper e-Socket and for the e-Writer/e-Writer plus it is required to use the correct programming adapter to plug into this writer.
Please note that the product does not support debugging. For debugging 8-bit MCUs, you need to use e-LinkPro2 with HT-IDE3000 software.
The e-WriterPro2 from Holtek supports an On-Line Programming Mode that requires connection to a PC and also an Off-Line Programming Mode that does not require a PC. In the Off-Line Mode, after downloading the programming data to the writer using the HOPE5000 using a PC, the writer can be operated without connection to a PC. In the On-Line Mode, a USB cable is required to connect the writer to a PC, after which it can be controlled using the HOP5000. Because Holtek devices are provided in many different package types, a range of corresponding programming adapters are supplied for each kind of MCU package. Therefore for the e-WriterPro2, it is necessary to use the proper e-Socket and for the e-Writer/e-Writer plus it is required to use the correct programming adapter to plug into this writer.
Please note that the product does not support debugging. For debugging 8-bit MCUs, you need to use e-LinkPro2 with HT-IDE3000 software.
- 1x e-WriterPro2
- 1x Type-A to Type-C cable
- 1x 5V USB power adapter
- 1x Cable for ICP with 2×6 pin connector (30cm)
Information on product safety:
- Only suitable for technically experienced users who are familiar with the product.
- Only suitable for the intended use.
- Improper use can lead to damage and injury.
- Observe the manufacturer's further safety instructions.
Manufacturer
HOLTEK SEMICONDUCTOR INC.
4F-2, No 3-2, YuanQu St.
NANKANG SO
Taipei 115
TAIWAN
https://www.holtek.com
Responsible Person for the EU
Atlantik Elektronik GmbH
Fraunhoferstr. 11a
82152 Planegg
Germany
info@atlantikelektronik.com